Tuesday, March 31, 2009

Where should I put lead tape on a driver to correct a wicked slice?John B., via emailGreat question, John. I asked Craig Allan, our club fitter at Sea Island Golf Club in Georgia, for help with this one. Here’s what he had to say:Within every clubhead design there is really only one optimal CG (center of gravity) position, so it is probably best to get fit to a clubhead that creates the ball flight you desire. That is why equipment makers intending to help golfers improve their ball flights are designing drivers with shafts that insert at different positions instead of drivers with adjustable weights.That said, it is possible to slightly adjust the CG and bias of a club with some specific placement of weight. This type of "tweak" is sometimes necessary when your club is close, but not perfect.For… More Draw/Less Fade = Weight on heelMore Fade/Less Draw = Weight on toe Adjusting the vertical trajectory is more difficult as loft is really the primary factor, but here are some guidelines… Higher with more draw or less fade = Weight on low heelLower with more draw or less fade = Weight on high heelHigher with more fade or less draw = Weight on low toeLower with more fade or less draw = Weight on high toeGood luck,GaleGolf Magazine Top 100 Teacher Gale Peterson teaches at the Sea Island Golf Learning Center in St. Simons Island, Ga.

You May Like

HOLE YARDS PAR R1 R2 R3 R4
OUT
HOLE YARDS PAR R1 R2 R3 R4
IN